Sani-Sleeve

Ask any property maintenance engineer to tell you the worst job they have to do.

Nine times out of ten the answer will be the urinal maintenance

Ask any cleaner to tell you the worst area he or she has to clean..

Nine times out of ten the answer will be the men’s washroom

Common Urinal Problems

APPEARANCE

Once fitted urinal waste outlets are normally left in place until the urinal bowl is replaced. After a while they get coated in uric salts and limescale on the inside with occasional cigarette burns on the outside. The addition of urinal  blocks makes them look more unsightly.

SMELL

Caused by ‘bad’ bacteria in biofilm, uric sludge and limescale build up on the internal surface of the waste outlet and waste trap. Also caused by unhygienic seepage from the connection between the waste outlet and the waste trap

BLOCKAGES

Caused by build up of uric acid sludge, fragments of chemical blocks  and limescale in the waste trap and pipe work

BEFORE Sani-Sleeve

The Sani-Sleeve is a low cost consumable and can be retro-fitted to existing urinals as well as fitted to new units. Its odour locking design lines the internal surface of the waste outlet and trap which is a major source of unpleasant smells. Sani-Sleeve units are replaced quarterly to ensure that the bio enzymes that line the sleeve continue to work well, and to maintain a high standard of appearance.

THIS KEEPS YOUR URINALS LOOKING AND SMELLING LIKE NEW!

‘Good’ bacteria and enzymes in the Sani-Sleeve deal with the cause of smells and blockage. They feed on the uric salts, which become soluble and are washed away with the next flush.

The Sani-Sleeve prevents seepage from the connection between waste outlet and trap, because the plastic sleeve acts as a funnel, and crystal growth in joints is reduced.

With Sani-Sleeve fitted